I made this template using some left over pegboard and raising it up a tad using some left over balsa. The cut went well. No problems cutting the hole. I used a 1/4 inch router bit with the DeWalt router. Had to make the template pretty low because the bit I used wasn't long enough to cut out a 1 1/8 inch hole.
I needed to do shallow cuts. Probably a 1/4 of an inch at a time. It was weird, any deeper than that, the sound it made was intolerable although it cut just fine.
Choosing a skimboard
-
Choosing a skimboard for the first time is no easy task. With the large
range of boards now on offer there are lot to choose from. Picking the
right board ...
-
Another aeon since I posted anything, the excuse the best I could possibly
have is all energies are being directed at projects outside of blogland.
Gone a...
Hello and Goodby
-
Hello everyone. Apologies for the temporary disappearance of Shipworm.
Shipworm and Gribble will remain as an archive for all to dig through and
remember t...